Swiss federal authorities

Mühleberg Nuclear Power Plant (permanent shutdown)

Type: Boiling water reactor

Start of commercial operations: 1972

End of commercial operations: 2019

Nominal thermal output of reactor: 1097 MW

Gross electrical output: 372 MWe

Net electrical output: 355 MWe

 

Click here for NPP Mühleberg

News

  • Delegation der spanischen Aufsichtsbehörde.
    News, Posts

    The Spanish regulatory authority and ENSI in talks on radiation protection

    From 6 to 8 May 2024, a delegation from the Spanish regulatory authority visited ENSI. Discussions focused on the topic of radiation protection, in particular exchanging of experience relating to the Leibstadt NPP and to the Mühleberg NPP, which is currently being dismantled.

  • KKB Beznau
    News, Posts

    Leibstadt and Beznau nuclear power plants can withstand infrequent severe earthquakes

    Both Leibstadt and Beznau nuclear power plants have shown that, in the event of or after a very severe earthquake, they can ensure that their reactors are stable and safe. Dose values of one or 100 millisievert which have to be complied with will not be exceeded even after earthquakes that are only to be…

  • Background articles, News, Posts

    All Swiss nuclear power plants comply with the updated earthquake safety standards

    For the second time since the Fukushima accident in 2011, power plant operators have demonstrated that their plants are capable of withstanding an extremely rare, severe earthquake. The safety case for a flood caused by an earthquake has also been checked. The findings from the safety proofs generated in the aftermath of Fukushima have been…

  • News, Posts

    Swiss nuclear power plants are unaffected by irregularities at the Le Creusot Forge

    The Swiss nuclear power plants use forgings for the safety-relevant main components with fully documented manufacturing and material quality certificates. This was confirmed by the operators in response to an enquiry made by the Swiss Federal Nuclear Safety Inspectorate (ENSI).

Background Articles

  • Background articles, Posts

    Dryout: Preventing inadequate cooling of fuel rods

    Heat is generated in the reactor as a result of nuclear fission. To guarantee optimum cooling of the fuel rods, their cladding tubes must always be covered with a film of water. If they are not completely covered with water in specific areas, this is referred to as “dryout”.

  • Background articles

    Radiation Measurement Technology

    Development and Research Work in the Field of Radiation Measurement Technology: this project deals with the verification and calibration of dosimetry systems and radiation measurement instruments. On the one hand, importance attaches to personal dosimetry, i.e. the measurement of the outer and inner radiation exposure for people.

Documents